Datamax-oneil E-Class Mark III 4xxxxxxx Operator’s Manual Bedienungsanleitung Seite 1

Operator’s Manual Basic and Advanced Models Serial# 4xxxxxxx or greater

4 Chapter 2 – Printer Setup 2.2.2 Interface Connections The printer can be connected to the host system via the parallel, serial, Ethernet or USB

Chapter 2 – Printer Setup 5 222...333 LLLoooaaadddiiinnnggg MMMeeedddiiiaaa  If the printer is equipped with an Adjustable Media Sensor it

6 Chapter 2 – Printer Setup 4) If using thermal transfer media (ribbon) proceed to Section 2.4 Loading Ribbon. Otherwise close the printer’s Cover

Chapter 2 – Printer Setup 7 2.3.2 Loading External or Fan-Fold Media Load media as follows: 1) Slide the Media Guides outward. 2) Slide the

8 Chapter 2 – Printer Setup 4) Route the media through the External Media Slot in the rear of the printer. Pull out enough media to exit the front

Chapter 2 – Printer Setup 9 2.3.3 Loading Media with the Peel and Present Option Load media for peeling (if the printer is equipped with the opti

10 Chapter 2 – Printer Setup 2.3.4 Loading Media with the Cutter Option Load media for cutting (if the printer is equipped with the option) as fo

Chapter 2 – Printer Setup 11 222...444 LLLoooaaadddiiinnnggg RRRiiibbbbbbooonnn The printer is capable of using C.S.I (Coated Side In) and

12 Chapter 2 – Printer Setup 2) Push out the Supply Hub and load the Supply Roll into the printer as shown. Depending on the size of the Supply Rol

Chapter 2 – Printer Setup 13 5) Route the ribbon from the supply roll to the Ribbon Core, as shown below. 6) If not already attached, affix the l

14 Chapter 2 – Printer Setup 2.4.1 Using the Ribbon Core Adapters When using ribbons with a 1” (25.4mm) I.D. core, a Core Adapter must be used. 1

Chapter 3 – Printer Operation 15 333 PPPrrriiinnnttteeerrr OOOpppeeerrraaatttiiiooonnn 333...111 IIInnntttrrroooddduuuccctttiiiooonnn

16 Chapter 3 – Printer Operation 333...333 MMMuuullltttiii---FFFuuunnnccctttiiiooonnn BBBuuuttttttooonnn The multi-function button performs di

Chapter 3 – Printer Operation 17 333...444 PPPrrriiinnnttteeerrr CCCooonnnfffiiiggguuurrraaatttiiiooonnn TTToooooolllsss The printer contain

18 Chapter 3 – Printer Operation 333...555 PPPrrriiinnnttteeerrr CCCooonnnfffiiiggguuurrraaatttiiiooonnn UUUtttiiillliiitttyyy (((NNNEEETTTi

Chapter 3 – Printer Operation 19 NETira CT Usage 1) Once installed launch the NETira CT configuration utility: 2) Be sure the printer is ‘ON’.

20 Chapter 3 – Printer Operation 3) At this point you may browse the Printer Component categories and make any changes necessary to the printer c

Chapter 3 – Printer Operation 21 333...666 WWWiiinnndddooowwwsss DDDrrriiivvveeerrr The Windows driver is located on the Accessories CD-ROM in

22 Chapter 3 – Printer Operation Important Notes: The Windows driver functions the same as any other Windows printer. While built-in help files prov

Chapter 3 – Printer Operation 23 333...777 MMMeeedddiiiaaa CCCaaallliiibbbrrraaatttiiiooonnn The printer is factory calibrated for operation w

Copyright Information CG Triumvirate is a trademark of Agfa Corporation. CG Times based upon Times New Roman under license from the Monotype Corpor

24 Chapter 3 – Printer Operation 3.7.2 Manual Media Calibration The Manual Media Calibration is intended for use when Quick Media Calibration prin

Chapter 3 – Printer Operation 25 5) Load Special Backing Media for Gap: Peel the label(s) off backing and place backing over the sensor and clo

26 Chapter 3 – Printer Operation 333...888 IIInnnttteeerrrnnnaaalll LLLaaabbbeeelllsss The following section details the resident information

Chapter 4 – Maintenance and Adjustments 27 444 MMMaaaiiinnnttteeennnaaannnccceee &&& AAAdddjjjuuussstttmmmeeennntttsss 444...

28 Chapter 4 – Maintenance Adjustments 444...222 CCCllleeeaaannniiinnnggg ttthhheee PPPrrriiinnnttthhheeeaaaddd Never use a sharp, hard, o

Chapter 4 – Maintenance and Adjustments 29 Cleaning Card Procedure If printing with direct thermal media, thermal transfer media with wax/resin ri

30 Chapter 4 – Maintenance Adjustments 444...333 RRRiiibbbbbbooonnn TTTeeennnsssiiiooonnn AAAdddjjjuuussstttmmmeeennnttt The adjustable ribb

Chapter 4 – Maintenance and Adjustments 31 444...444 AAAdddjjjuuussstttaaabbbllleee MMMeeedddiiiaaa SSSeeennnsssooorrr The optional Adjustab

32 Chapter 4 – Maintenance Adjustments 444...555 PPPrrriiinnnttthhheeeaaaddd RRReeeppplllaaaccceeemmmeeennnttt If the Printhead becomes damage

Chapter 4 – Maintenance and Adjustments 33 5) Loosen the Printhead Screw and allow the Printhead to fall free. 6) Remove the Printhead Cable.

Agency Compliance and Approvals C US Listed UL60950-1, Second Edition, Information Technology Equipment CSA C22.2 No. 60950-1-0

34 Chapter 4 – Maintenance Adjustments 444...666 PPPlllaaattteeennn RRRooolllllleeerrr RRReeeppplllaaaccceeemmmeeennnttt The Platen Roller c

Chapter 4 – Maintenance and Adjustments 35 444...777 DDDooowwwnnnllloooaaadddiiinnnggg FFFiiirrrmmmwwwaaarrreee aaannnddd FFFooonnntttsss

36 Chapter 4 – Maintenance Adjustments

Chapter 5 – Troubleshooting 37 555 TTTrrrooouuubbbllleeessshhhooooootttiiinnnggg 555...111 IIInnntttrrroooddduuuccctttiiiooonnn Occ

38 Chapter 5 – Troubleshooting Skips every other label (print quality is good, but every other label is skipped):  The label is formatted too cl

Appendix A – Specifications 39 AAA SSSpppeeeccciiifffiiicccaaatttiiiooonnnsss Mechanical Width 8.01 inches (20.4 cm) Depth 7.36 inches (

40 Appendix A – Specifications Media / Ribbon Media Types Roll-Fed, Die-Cut, Continuous, Fan-Fold Max. Media Width 4.4 inches (110mm) Min. Medi

Appendix A – Specifications 41 Approved Media To achieve optimum print quality and maximum printhead life, Datamax-O’Neil specifies the use of Data

42 Appendix A – Specifications

Appendix B – Ethernet Setup 43 BBB EEEttthhheeerrrnnneeettt SSSeeetttuuuppp BBB...111 NNNeeetttwwwooorrrkkk CCCaaarrrddd SSSeeetttuuupp

i CCCooonnnttteeennntttsss 111 GGGeeettttttiiinnnggg SSStttaaarrrttteeeddd ...

44 Appendix B – Ethernet Setup B.1.1 Wired Configuration - Static IP Address: NETira CT (located on the Accessories CD-ROM) is a Windows based co

Appendix B – Ethernet Setup 45 BBB...222 PPPrrriiinnnttteeerrr’’’sss IIInnnttteeerrrnnnaaalll WWWeeebbb PPPaaagggeeesss 1. Open yo

46 Appendix B – Ethernet Setup Generic Network Settings Page Network Interface Network Interface • Wired Ethernet • Disabled TCP Print Ser

Appendix B – Ethernet Setup 47 Wired Ethernet Settings Page Acquire Address Method Acquire Address Method Controls IP Address discovery, where: •

48 Appendix B – Ethernet Setup BBB...333 IIInnnssstttaaalllllliiinnnggg ttthhheee PPPrrriiinnnttteeerrr DDDrrriiivvveeerrr Install the

Appendix B – Ethernet Setup 49 9 Insert the Accessories CD-ROM and click Browse. 10 Browse to the \DRIVERS\ folder on the CD-ROM. Ensure the fi

50 Appendix B – Ethernet Setup

Glossary 51 GGGlllooossssssaaarrryyy alphanumeric Consisting of alphabetic, numeric, punctuation and other symbols. backing material The sil

52 Glossary font A set of alphanumeric characters that share a particular typeface. gap A space between die-cut or notched labels used to sense the

ii 444 MMMaaaiiinnnttteeennnaaannnccceee &&& AAAdddjjjuuussstttmmmeeennntttsss ...

Chapter 1 – Getting Started 1 111 GGGeeettttttiiinnnggg SSStttaaarrrttteeeddd 111...111 IIInnntttrrroooddduuuccctttiiiooonnn The E-Class

2 Chapter 1 – Getting Started

Chapter 2 – Printer Setup 3 222 PPPrrriiinnnttteeerrr SSSeeetttuuuppp 222...111 IIInnntttrrroooddduuuccctttiiiooonnn This section explai