Datamax-oneil microFlash 2te Quick Reference Programming Guide Bedienungsanleitung PDF herunterladen (Seite 39)

Using Easy Print Mode

Datamax-O’Neil Quick Reference Programming

Configure CardReader {CCR:nnn} Original

MF2, MF3, 2t, 4t

Radio Ready

2t, 3l, 4t

{

A left bracket begins the command set.

CCR:nnn

The CCR command requires data only to

configure the general way the card reader

uses the LED indicators when reading a card.

Use the following information:

nnn = HOST: The host needs to control the

LEDs be sending the appropriate commands

to turn the red and green LEDs off, on, or to

flashing.

nnn = AUTO: The printer controls the LEDs

and beeper. All tracks enabled must read

“good” to get the green LED and two beeps

indicating a good read.

nnn = AUTO1: The printer controls the LEDS

and beeper. Any one track must read “good”

to obtain the green LED and two beeps

indicating a good read.

}

A right bracket ends the command set.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 71 72

Keine Kommentare

Datamax-oneil microFlash 2te Quick Reference Programming Guide Bedienungsanleitung Seite 39