Datamax-oneil Workstation series User Guide Bedienungsanleitung PDF herunterladen (Seite 27)

Connections and Setup | 3

19 Workstation Series User’s Guide

Sensor Calibration

Sensor calibration is set during the manufacturing process and should only need to be

performed after upgrading the printer’s software. This is indicated by the red LED

blinking slowly after power-up.

1. Remove the paper from the printer.

2. Close and latch the printer cover.

3. Press the Reset, Stop/Resume, and the Feed/Cancel buttons together with one

short press.

Note: The green LED will have a fast blink sequence.

Printer Settings

All printer settings can be adjusted in the configuration utility or the printer’s internal web

pages. Refer to the Help section in the utility for more information.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 44 45

Keine Kommentare

Datamax-oneil Workstation series User Guide Bedienungsanleitung Seite 27