Datamax-oneil DPL Programmer’s Manual Bedienungsanleitung PDF herunterladen (Seite 108)

Extended System-Level Command Functions

100

STX Kp Module Protection

This command controls memory module protection. When “protected”, a module will

ignore format, downloads and delete commands. This command can be useful to add

data to reserved modules (see Appendix K for a listing of the memory modules). There

are two module types: RAM (volatile) and Flash (non-volatile).

• RAM - When protected and if power is cycled or if the printer is reset, the module

state resets to unprotected.

• Flash - When protected, the module can be temporarily unprotected; however, if

power is cycled or if the printer is reset, the module state resets to protected.

Syntax:

STX>Kpmf

Where:

Module ID – Range A to Z (See Appendix K).

Flag specifying Enable or Disable protection, where:

0 = disable protection; and,

1 = enable protection.

Sample:

<STX>KpY0

The sample above disables protection for Module Y; graphics may

now be downloaded to the module and, on subsequent resets,

these graphics will be protected.

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 295 296

Keine Kommentare

Datamax-oneil DPL Programmer’s Manual Bedienungsanleitung Seite 108