
91
Warning Messages
The following messages may be displayed:
Maintenance timer has expired
Printhead voltage above maximum specifications
Printhead voltage below minimum specifications
Unidentified printhead installed
Printhead is cooling down
PAPER CALIBRATION MARGINAL
Paper sensor calibration marginal
PERFORM CALIBRATE SENSORS
There is a need to run Calibrate Sensors
Printhead needs to be unlatched
Printhead unlatched while in idle
The cutter is enabled but not installed
The GPIO is enabled but not installed
PRESENT SENSOR NOT INSTALLED
The present sensor is enabled but not installed
The ribbon controller is enabled but not installed
The rewinder is enabled but not installed
The cutter cover is not magnetically closed
The printer has received settings intended for a different printer
model
The paper width sensor is malfunctioning
The rewinder take up is close to capacity
Kommentare zu diesen Handbüchern