Datamax O'Neil H-8308P Betreibershandbuch PDF herunterladen (Seite 35)

3.4.3 Setting the Media and Ribbon Parameters Manually (Advanced)

There are times when all print parameters must be set manually. This can happen when a

new or specialized media or ribbon is being used.

Note: Some values may be grayed-out, meaning they are automatically set by default or not

available for the particular printer model. To change these values, select the Auto button next

to the value field and then select the green Accept button to confirm your choice to change to

manual mode.

Note: Please see the Menu section for more information.

1. Select Menu > Advanced > Media.

2. Select the Paper Sensor Type field until the correct paper type appears. The

options are as follows:

# Gap

# Mark on Bottom

# Notch

# Continuous

3. Select the Ribbon Mode field until the correct option appears. The options are as

follows:

# None - for direct thermal printing

# Coated In - for thermal transfer printing

# Coated Out - for thermal transfer printing

4. Tab to the next screen and enter values for Heat and Heat Balance.

5. Tab to the next screen and enter values for Rewinder Tension.

6. Tab to the next screen and enter a value for Ribbon Low Diameter, Gap/Mark Offset

and Gap Mark Noise.

7. If media levels are to be tracked, tab to the next screen and enter values for Ribbon

Length, Form Length and Number of Forms. These parameters are used for media

tracking when Paper Change Warning is enabled.

8. Select the Home button and select the green Accept button to confirm the settings.

3.4.4 Load a Saved Media File

For media and ribbon settings that are frequently used, media setup files can be saved to the

printer’s internal memory for easy access. For more information on saving the user setup files,

refer to the section titled Setups from the

Tools > User Files menu section. To select an

internally saved media setup file, perform the following steps:

1. Select Menu > Basic > Media > User Media.

2. Using the up and down arrows, select the appropriate Internal Media Setup File.

3. Select the green Accept button and confirm the settings.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 115 116

Keine Kommentare

Datamax O'Neil H-8308P Betreibershandbuch Seite 35