Datamax O'Neil H-8308P Betreibershandbuch PDF herunterladen (Seite 29)

3.2 Media Sensor Adjustment

Position the Media Sensor for proper label detection:

A. Raise the Printhead Assembly. Note the Red Dot (see illustration below) that identifies

the location of the Media Sensor.

B. Grasp the Slide Tab to position the Red Dot according to the Media Type, as detailed

below.

Media Sensor Adjustment

Media Type

Red Dot Position

Die-cut

Centered over a label

Notched

Centered over a notch

Reflective

Centered over a black mark

Continuous

Centered over the material

C. Lower the Printhead Assembly then rotate the Printhead Latch completely clockwise.

D. If necessary, return to Media Loading to complete the setup process; otherwise, close

the cover. With READY displayed, press and hold the FEED Key until at least one gap (or

mark) advances; see Section 3.4.

If using REFLECTIVE or CONTINUOUS media, select the appropriate SENSOR TYPE;

see Section 3.4 Configuring Media and Ribbon Settings.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 115 116

Keine Kommentare

Datamax O'Neil H-8308P Betreibershandbuch Seite 29